Beverage filling machine preparation note:
1. Check the lubricating parts of the equipment before starting. If the oil cups and gears are not lubricated, the corresponding lubricating oil must be added.
2. Check whether the beverage filling machine is loose or not. If there is a need to tighten, and if there is a change in its position, it is generally necessary to run at a low speed before running automatically.
3. Check that the tank level is adequate and that there are tools or other things missing from the equipment. You must ensure safety before you can operate.
4. Whether the valves are in normal condition and whether the pressure meets the equipment requirements.

Note on Operation of Beverage Filling Machine:
1. When running time, pay attention to whether the beverage filling machine makes abnormal sounds. If there is a need to overhaul, find out the reason to clear the fault.
2. Do not stand on the device when it is running.
3. Check whether the cover is sterilized, whether the cover of the cover is ozone added, and whether the pure water pump of the cover is properly supplied.
4. If the filling valve leaks, there are two possibilities: First, the filling valve is opened and not reset, and second, the sealing ring of the filling valve is not sealed well. It can be removed and checked and replaced.
5. If there is a high cover and a crooked cover, there are the following situations: First, there is a problem with the combination of the lid and the bottle, and it may be one of the problems; The second is that the torsion of the cover head is not enough. If it can be rotated by hand, find out that the cover head will increase the torsion until it meets the requirements; Third, there is a problem with the upper bottle, mainly in the overpass of the star wheel, and it is possible that the cap may be loosened and must be reset.
6. If you remove the bottle from the bottle, there are the following situations: First, there is a problem with the bottle opening on the air channel. The second is that the spring of the bottle washer has lost its elasticity, or the bottle block has been loosened or worn. There is no way to pinch the bottle, and it can be replaced.
7. If the torque of the spin head is not always adjusted, replace the magnet and check the inner spring. If the elastic force is not enough, change it. In addition, the spin head pressure cover can not be returned. The inspection must be removed. Replace parts.
8. If the cover is always blocked at the small star wheel of the cover slot, the position of the star wheel must be adjusted until it is smooth. If the cover holder’s exit cap, first check whether the exit assembly is clamped, and whether the air pressure of the back cover is too large., and then adjust its position or pressure.
9. If the cover is not smooth, you can increase or decrease the spring pressure on the cover plate, and you must also check whether the excessive part of the contact with it is normal.